22
Setting the cutting deck height
Before using riding mower, raise the height of cutter head to the most suitable cutting
position for your lawn.
• Stop the mower and disengage blades.
• Turn the key to STOP position and press the parking brake.
• To raise the cutting deck, grasp the deck height adjustment lever, push right to
disengage from slot, move toward the back of the mower, then push left into slot to
secure.
• To lower the cutting deck, grasp the deck height adjustment lever, push right to
disengage from slot, move toward the front of the mower, then push left into slot to
secure.
Note: When setting the height of the cutter head, grasp the handle of the height
adjustment lever, only when it is fixed Release your hand only when you are in the
required card slot. If the adjustment lever is released quickly, it may cause a danger of
squeezing or pulling the operator's hand.
Install the rear duct
1.Adjust cutter (7)to lowest gear.
2.Insert the duct 1 to grass catcher deeply.
3.Hold the side cover switch and flip the side cover up.
4.Place duct 2 in bayonet.
To Next Page
Loading...
