Why does my FXA Log Splitter fail to split logs?
If the FXA Log Splitter fails to split logs, it might be due to several reasons. The log may be improperly positioned. The wedge cutting edge could be blunt. The sizes or hardness of the log may exceed the machine's capacity, so reduce the log sizes before splitting.
What to do if oil leaks from my FXA FXA502018666 Log Splitter?
If you notice oil leaks around the cylinder ram or from other points of your FXA Log Splitter, it could be due to several reasons. Air might be sealed in the hydraulic system during operation. In this case, loosen the Bleed Screw by 3-4 turns before operating the log splitter. The Bleed Screw might not be tightened before moving the log splitter, so tighten it up. The Oil Drain Bolt might not be tight, so tighten the Oil Drain Bolt.
General| Brand | FXA |
|---|---|
| Model | FXA502018666 |
| Category | Log Splitter |
| Language | English |
To Next Page
