Shortwave Infrared Paint Curing Lamp
INSTRUCTION MANUAL
*Please read this manual carefully before installing or servicing this equipment.
Precaution
1. This equipment is designed for paint curing application. Keep a safe distance
between emitter and panel. Improper servicing can cause paint surface
damage.
2. Installation and service must be performed by a qualified installer or service
agent.
3. The system has been designed for easy installation, low operating costs and
minimal maintenance. The warranty does not cover lamp tube defects
resulting from misuse or improper operation.
4. Disconnect power source when the equipment not in use for long time
5. The lamp tube should not be perpendicular to the ground when the
equipment is operating. Otherwise, it will shorten the life of the lamp tube.
6. Turn off the equipment after using. Place the equipment in a safe place to
avoid damage to the lamp tube.
Technical Parameter
220V 50/60Hz Single Phase
To Next Page
Loading...