Why can't I adjust the temperature and time on my FY-TECH FY-3D Heater?
There might be a problem if you are unable to adjust the temperature and time on your FY-TECH Heater. This could happen because of a switch imbalance, so check the installation of the switch. Alternatively, the keyboard might have an exclusion, in which case you should check the keyboard exclusion.
What to do if the digital display is blank or incomplete on my FY-TECH Heater?
If the digital display on your FY-TECH Heater is blank or incomplete, it could be due to a couple of reasons. First, check the flat wire, as it might be unplugged in the circuit board. Second, the digital display itself might be damaged, so inspect the digital display.
Why won't the light tube turn off on my FY-TECH Heater?
If the light tube on your FY-TECH Heater will not turn off, the control silicon may be damaged. In this case, check the control silicon.
Steps for installing the base of the curing lamp.
Steps for installing the column of the curing lamp.
Steps for installing the cassette of the curing lamp.
Configure the equipment's distance parameters for optimal curing.
Adjust the curing temperature using the power adjustment control.
Set curing parameters for the automatic mode based on paint requirements.
Instructions for operating the equipment in automatic curing mode.
Instructions for operating the equipment in manual curing mode.
Instructions for operating the equipment in pulse curing mode.
Common problems, their causes, and solutions for the equipment.
Step-by-step guide on how to replace the light tube.
To Next Page
General