G-CYCLE L8 Pro - 8 Folding; Folding Mechanism and Carrying

To Next Page

To Previous Page

8 Folding

NOTE:

7.1 The battery must be fully charged before use. Only when the battery is fully charged can its use eect be guaranteed. After fully

charging the electric scooter, you should immediately unplug the power supply. Remember not to charge overnight. Overcharge or

undercharge will consume the battery life.

7.2 If you do not use the scooter for a period of time, you should also pay attention to charging the scooter regularly to avoid running

out of battery power. At the same time, be careful not to remove the battery randomly.

7.3 Remember not to wash the scooter with water when the power is turned on. This will cause damage to the scooter and threaten

personal safety. Please make sure that water cannot enter the inside of the machine.

7.4 When placing it, it must be stored reasonably. Do not place it in a place exposed to sunlight or rain, avoid sunlight exposure, and

avoid the rain. After all, it is an electronic product, and it must ensure its safe performance.

7.5 The wheel is the most vulnerable part of an electric scooter, so in daily maintenance, proper inspection and maintenance should be

carried out on the wheel. The user can shake it along the tire axis from time to time and feel its ﬁrmness by hand. The tightness of the

screws is also a part of the wheel that must be checked frequently. Only by fully tightening the screws and ensuring the ﬁrmness of

the assembly can travel safety be ensured.

Multi-function Description about the Power Button.

1. Turn on/o the scooter. Keep pressing the power button for two seconds to turn it on/o.

2. Turn on/o the lights. After turning on the scooter, quickly press the power button twice to turn on/o the LED light.

3. Adjust the speed. Press the power button once to adjust the speed. (It has two speed levels, 9mph and 15mph).

4.Change the speedunit (mph orkm/h). Quickly press the power button three times.

5. Cruise Control Mode. Quickly press the power button four timesto activate the cruise control mode, and then if the speed is

maintained at a certain speed for 8-10 seconds, you’ll enter into the cruise control mode and you’ll hear the beep sound twice. When

you pull the brake or throttle again, the scooter will end the cruise control mode, and you will hear a beep sound.

6. The power will turn o automatically after 5 minutes of no operation.