G-Force SL Series User Manual

Black / Blue wires to black
Negative battery Terminal /
Piggy Back Spade Connectors
Red wires to Red Positive
Battery Terminal / Piggy Back
Spade Connectors
Power Pack Wires
Positive wire to RED wire
Negative wire to BLACK wire
(Remove “Dummy Wires” before
connecting power pack wires)
Locate the terminal block fastened to the top of the circuit board support tray. Remove the
“Dummy” wires. Connect the power pack positive wire to the mating wire with the red end and
connect the power pack negative wire to the mating black wire. Plug the piggy back spade
connections to the battery terminals on the battery. Note the polarity (Red positive wires to Red
battery terminal, Black / Blue Negative wires to Black battery terminal). The board should now
be powered and great care should be taken to avoid shorting out or otherwise damaging the
circuit board.
Terminal Block
Terminal Block
Power Pack Wires
RED wire to RED (ACTIVE) wire
BLACK wire to NEGATIVE wire
1.5mm Twin Active Low Voltage
Cable (RED active / WHITE neutral)
Weather Proof
Enclosure
If the power pack wires need to be extended then we recommend you use a terminal block /
joiner. Place the terminal block / joiners into a small enclosure for protection and outdoor
installation.
Power Pack Wiring
Instructions
Circuit board support tray
Battery Wires RED is Positive
BLACK is Negative
Power Pack
Red LED—Power On
Amber LED—Charging
Green LED— Baery Charged

G-Force SL Series Specifications

General

Brand	G-Force
Model	SL Series
Category	Garage Door Opener
Language	English