20
n Select the check box “Float” to enable 24 bit recording.
n Select the desired Wave/... In Device for input.
n Make sure that ‘monitor’ is checked.
n Set the ‘Record Offset’ to 0.
Samplitude 2496 also has a number of buffer settings for digital
audio. These can be left at their default value of 8192. The ‘Buffer
number’ should be set to 6.
Setting up SAW for WavePRO
SAW is one of the original multi-track digital audio programs for the
PC and it is designed to fully utilize multi-channel cards. Here are the
steps to configure SAW for WavePRO.
n Select the menu item, ‘Options | Audio Hardware Setup’. A
setup dialog box will appear.
n For ‘Wave Device 1’ select ‘Ch 1/2 Out Wave/...’
n Make sure that ‘Device 1 interrupt Hook’ is set to ‘None’
n For ‘Wave Device 2’ select ‘Ch 3/4 Out Wave/... ’
n Make sure that ‘Device 2 interrupt Hook’ is set to ‘None’
n Set ‘Preload Buffer Queue’ to ‘8’.
If you have difficulties, SAW has lots of good troubleshooting
information within the application help files.
Setting up Sound Forge for WavePRO
Sound Forge is a very popular digital audio editor that has a number of
advanced features. Use the following steps to configure Sound Forge.
n Select the menu item, ‘Options | Preferences’. A tabbed dialog
will be displayed. Select the “Wave” tab.
n For ‘Playback’, select the desired Wave/... Out device.
n Leave the option, ‘Interpolate play position for inaccurate
devices unchecked. Yes, WavePRO is indeed an accurate
device J. Also, leave the ‘Play position bias’ at 0.
n For ‘Record’, select the desired Wave/... In device.
n Again, leave the option, ‘Interpolate record position for
inaccurate devices unchecked and leave the ‘Record position
bias’ at 0.
n Set ‘Total Buffer Size (kilobytes)’ to 512.
n Set ‘Preload Size (kilobytes)’ to 64.
To Next Page
Loading...