Gadget Labs WavePRO - Getting Started; Installing the Wavepro Hardware and Software Drivers

2
INSTALLING THE WAVEPRO HARDWARE
& SOFTWARE DRIVERS
WavePRO interfaces are designed to be truly Plug and Play.
Installation in most systems should take only a few minutes.
If you have any difficulties with installation or operation of
WavePRO, check the Troubleshooting section later in this guide.
NOTE: if you are installing 2 or 3 WavePRO cards in a PC, you
will need to connect the Sync Cable between the cards
before installing. Please see page 6 for instructions.
STEP ΠShut down and turn off your PC
Before you begin installing your WavePRO interface please note:
Static electricity can damage electronic components!
Take the following precaution before you begin installation:
Shut down and turn off the PC but leave it plugged in. Touch the
metal chassis of the PC to drain the static from your
bod J before you touch the WavePRO PCI card.
Next, unplug the PC's power cable. Follow the steps in your PC's user
manual and remove the PC chassis cover.
GETTING STARTED
Here’s a list of stuff that’s included with this package:
Wave/824 Wave/496 Wave/424
WavePRO PCI card
üü üü üü
Computer interface cable
(6 feet / 2 meters)
üü üü
MIDI adapter cable
üü
Patch Box: 4 in, 4 out half-rack
üü
Patch Box: 8 in, 8 out rack-mount
üü
AC Power Cube
üü
4 Rubber feet for bottom of Patch
Box. For placing patch box on a
desktop instead of equipment rack.
üü üü
WavePRO software drivers diskette
üü üü üü
Applications & Demos software CD
üü üü üü
User’s Guide (duh)
üü üü üü