Gadget Labs WavePRO - Page 28

26
WavePRO interface, and are experiencing lockup problems during
the installation, follow these steps:
-Click on Start -> Settings -> Control Panel -> Multimedia.
-Click the Devices tab, then Audio Devices. Double click Gadget Labs
Wave/....
-Click the bubble called 'Do not use Audio features on this device' and
hit OK.
-Keep hitting OK to close everything, and reboot your computer.
-After your computer has rebooted, proceed with the Logic Audio 4
installation.
-After Logic Audio 4 is installed, reboot and go back into the Control
panel and re-enable the WavePRO interface.