STEP ‘ INSTALLING THE SOFTWARE DRIVER
Windows® 95/98:
n After installing the WavePRO hardware, reconnect the PC's power
cord, turn on the PC power switch and boot your PC.
n As Windows starts up, it will recognize the WavePRO interface and
automatically install it.
n The following prompts will be displayed by the system:
‘New Hardware Found’
‘PCI Multimedia Audio Device’
‘Select which driver you want to install for your new hardware’
n Choose: ‘Driver from disk provided by hardware manufacture’
n Insert the WavePRO Drivers Diskette into the floppy drive.
The next steps are slightly different depending on if you're using
Windows 95 or Windows 98.
Windows 95:
n Make sure that ‘Copy Manufacturer’s files from:’
shows, ‘A:\’
n Click OK
Windows 98:
n A new message box will appear, with a list of search
options and check boxes. Uncheck everything except,
'Floppy Drive'. Click 'Next'.
n Windows will display a new message box saying it found
the drivers, and asks you to Click OK to install.
n The driver files will be copied and the system automatically setup
STEP • Connect the Power Cube to an AC outlet
Connect the Power Cube to an AC power outlet.
This can be directly into a wall outlet or a power
strip.
When this power is on, the green light on the
front of the Wave/824 will turn on.
The Patch Box does not have a power on/off
switch and it's OK to leave it powered on or off
when not in use.
5
To Next Page
Loading...