INSTALLATION / PRIMING THE PUMP
Check that all components
are positioned correctly.
Press the ON/OFF switch
to turn on the machine. The
light switches on.
Open the knob.
Wait until a steady stream
of water fl ows out from the
nozzle.
The machine is ready for
use when the light switch-
es on.
See
rating plate
Take out the water tank. Insert the water tank.
Place a container beneath the
steam wand.
The messages displayed by the machine during operation are shown on pg. 24.
Note: You must prime the
pump before starting up the
machine for the fi rst time, if
it has been inoperative for a
lengthy period or if the water
tank has been completely
emptied.
Wait about 5-6 minutes, so
that the system can warm up
uniformly.
Remove the container.
Press the button to begin
loading the circuit.
Plug the other end of the
cord into a suitable electric
socket.
Fill the tank with cold drink-
ing water. Do not exceed the
maximum level.
Press the button and close
the knob to stop loading
the circuit.
Insert the plug into the
socket on the back of the
machine.
INSTALLATION
18
To Next Page
Loading...
