1.1 Documentation required
The following technical documentation is required for repairs:
Instruction booklet for specific model.
Technical documentation for specific model (diagrams, exploded drawings).
1.2 Tools and equipment required
As well as the standard equipment, the tools listed below are required.
1 special screwdriver with Torx T10 tip.
1 digital thermometer with full 200°C scale.
This must be suitable for measuring in liquids and on surfaces.
1 set of pliers for Oetiker clamps.
1 pincer.
1 CC -A - Vdc tester.
1.3 Safety warnings
Before starting operations on the machine, consult the relative instruction booklet.
Observe all current standards related to the repair of domestic appliances.
Always disconnect the power plug from the mains before carrying out repairs. Simply turning
off the main switch is not sufficient to prevent electrical discharge.
This domestic appliance is rated with insulation class I.
On completion of repairs, the insulation and dielectric rigidity tests must be performed.
1/2
TALEA Section 01
REV00 - August 06
To Next Page
Loading...
Need help?
General
Weight and Dimensions
