El
NOTE: To immediately prepare
another coffee, fill the boiler with water
so that it will be heated to the correct tem-
perature. If not, the coffee may have a
,burned
taste. Place an empty cup on the
grating. Do not insert the filter holder.
Press the coffee switch (2) and fill the cup
with water. Release the coffee switch.
Now you can prepare another cup of cof-
fee. The boiler should be filled each time
the machine has been used to make steam.
HOW TO OBTAIN HOT WATER
El
Follow the procedure described in the Preparation section.
LLI
Place a pitcher under the steam nozzle (10).
tz
Press the hot water button (3) and slowly turn the steam dial (7) anticlockwise
to make the hot water flow.
H
Once the desired amount of water has been obtained, turn the steam dial
clockwise and release the dispenser cut-off button. Then remove the pitcher.
CLEANING INSTRUCTIONS
q
IMPORTANT: Clean the steam nozzle (10) after immersing it in milk to pre-
vent milk from depositing. To make cleaning easier, as indicated in figure B, the
outer part of the steam nozzle can be quickly removed by pulling it down. Use a
damp cloth to clean the end of the nozzle and open the steam dispenser tap. Allow
the steam to flow for one or two seconds to clear out the nozzle. Clean the outside
of the steam nozzle. If necessary, use a needle to clean the steam jet hole.
LZI
Clean the filter holder (15) and the filter (14)
regularly with warm water.
El
Clean the casing of the machine with a damp
cloth.
q
Remove the basin ( 12) and the grating
(13),
and
wash them with water. Do not use abrasives.
FIG. B
El
Clean the gasket inside the coffee dispenser unit
(16). Keep it clean.
H
Unscrew and periodically clean the diffusor
(21),
depending on how much the machine is used.
NOZZLE
STEAM NOZZLE
20
To Next Page
Loading...
