Gallagher FENCE - Troubleshoo Ng

16
Status LED
Status LED will only operate once a er the Energizer has been turned
on.
One fl ash Registra on sent to Energizer
Two fl ashes Registra on with Energizer confi rmed
TROUBLESHOOTING
Problem Causes Solu on
Fence Monitor zone
does not appear
on the Energizer
Controller
Ba eries are fl at
Ba eries or ba ery
holder are installed
incorrectly
Fence Monitor
needs rese ng
There are 2 fence
monitors on the
same zone
The fence voltage
is less than 500V
The energizer
is incorrectly
connected to the
fence
Replace ba eries
Install ba eries
/ ba ery holder
correctly
Remove ba ery
holder for 5 minutes
to reset the Fence
Monitor
Give each fence zone
a unique number. See
p. 8.
Repair fence
Connect your earth
system to the earth
terminal (on the le ),
and the fence to the
fence terminal (on
the right)
Zone current
measures lower
than expected
Poor Fence
Monitor earth
Fence installa on
Ba eries are low
Use addi onal earth
stakes
Check all power to
zone runs through
the Fence Monitor
Replace ba eries
Error 21 is displayed
on a fence zone
Communica on
with Fence
Monitor has been
lost
Check the Fence
Monitor