Part Number: 3E2453 R1 | 1
Installation Note | Gallagher T10 Mifare Reader
Installation Note
Gallagher T10 Mifare Reader
The Gallagher T10 Mifare Reader
The Gallagher T10 Mifare reader is a smart card proximity reader. It can
be installed as either an entry reader or exit reader.
The reader can read Mifare DESFire EV1, Mifare Plus and Mifare Classic
cards.
The reader sends information to the Cardax FT Controller and acts upon
information sent from the Cardax FT Controller. The reader itself does not
make any access decisions.
The Gallagher T10 Mifare reader uses the “Cardax IV Reader”
communications protocol to communicate with the Cardax FT Controller.
This equipment contains components that can be damaged by
electrostatic discharge. Ensure both you and the equipment are
earthed before beginning any servicing.
To Next Page
