Why is the water from my Galmet SGW 120 dirty?
If the water from your Galmet Water Heater is dirty, it could be due to a large amount of sediment in the tank. In this case, clean the tank of sediment. Another possible cause is a worn-out magnesium anode, which requires replacing. Note that replacing the magnesium anode is not covered by the warranty.
What to do if the safety valve leaks in Galmet Water Heater?
If the safety valve on your Galmet Water Heater is leaking, the touching surfaces of the safety valve might be dirty or defective. To resolve this, clean or scrub these surfaces. Another cause could be excessive water pressure in the network. If so, install a flow control device.
How to fix the safety valve that does not open in Galmet Water Heater?
If the safety valve on your Galmet Water Heater does not open, even when doing a blow through, it might be seized. Try to clean or replace the valve.
Details the components and functionalities of the water heater.
Provides a diagram of the wall-mounted model's connections and dimensions.
Details performance and dimension data for wall-mounted models.
Shows diagrams for free-standing models (100-140L).
Illustrates the free-standing 200L model's layout.
Provides technical data for free-standing models (100-200L).
Lists the advantages of using a titanium anode for corrosion protection.
Addresses common issues and solutions related to the titanium anode system.
General| Brand | Galmet |
|---|---|
| Model | SGW 120 |
| Category | Water Heater |
| Language | English |
To Next Page
