Than transmitter already in memory and then once with the new. When programmation is done, the
blinker flash once. Attention: function must be enabled, refer to “advance menu ”-auto learning
transmitters. The new code takes the same channel as the one used to insert it.
Board settings
Base Menu
Push enter 1 for at least 1 second to enter base menu.
OL is on the display, with up/down it’s possible to select other functions of this menu.
To exit this menu select EX or push up and down together.
After 2 minutes without actions, the control unit exits itself from this menu.
Figure 19
To Next Page
Loading...