Why doesn't my Gamatech Gate Opener remote control work?
If the Gamatech Gate Opener remote control isn't working, first replace the remote control battery. If that doesn't solve the issue, you may need to re-conduct the remote control learning process.
What to do if Gamatech PK300DC Gate Opener won't open or close and the display is not lit?
If your Gamatech Gate Opener isn't opening or closing and the display is off, check the following: 1. Ensure the power supply is switched on. 2. Inspect the fuse and replace it if it's burned. 3. Verify the control board power wiring, and rewire it according to the instructions if necessary.
Why does my Gamatech PK300DC open but not close?
If your Gamatech Gate Opener opens but won't close, consider these potential causes: * Check the photocell wiring. If you're not using a photocell, ensure that terminals 5 and 6, and 5 and 7 are short-circuited. If you're using an infrared sensor, verify the wiring is correct and the photocell is normally closed (N.C.). * Confirm that the photocell mounting position allows for mutual alignment. * Ensure that the photocell is not blocked by any objects; remove any obstructions. * Reduce the obstacle sensitivity if it is set too high.
Why does my Gamatech Gate Opener stop or reverse in the middle?
If the Gamatech Gate Opener stops or reverses mid-motion, it might be due to: 1. Insufficient motor output force. Check if the transformer power is normal; replace the transformer if it's not. 2. Overly sensitive obstacle detection. Adjust the TR2. 3. An obstruction in the gate's path. Remove any obstacles.
Why does the leakage switch trip on my Gamatech PK300DC Gate Opener?
If the leakage switch tripped for your Gamatech Gate Opener, it's likely due to a short circuit in either the power supply line or the motor line. You should check the wiring to identify and correct the short circuit.
How to extend the remote control range of my Gamatech PK300DC Gate Opener?
If the remote control distance for your Gamatech Gate Opener is too short, it could be due to signal blockage. Try connecting an external receiver antenna, positioning it 1.5 meters above the ground.
What to do if Gamatech PK300DC motor makes noise but the gate doesn't move?
If the Gamatech Gate Opener motor makes noise but the gate doesn't move when you press the OPEN or CLOSE button, it suggests that the gate's movement is not smooth. Adjust the motor or the gate itself based on the specific situation.
List of optional accessories included with the gate opener system.
Diagram illustrating the installation layout of the gate opener components.
Details on the dimensions and physical specifications of the main engine and associated parts.
Detailed instructions for installing the gate opener system.
Confirms door operation, sets lock distance, and determines mounting height for the main engine.
Instructions for installing wall, connecting, and front mounting brackets for the main engine.
Procedure to unlock the main engine using the manual release bar.
Detailed steps for physically mounting and connecting the main engine to the gate.
Guidance on inward/outward opening directions and associated maximum swing angles.
Dimensions of the control box unit.
Detailed explanation of control board terminals, inputs, outputs, and their functions.
Guide to accessing and using the base menu for operating logic, learning codes, and setting times.
Detailed explanations for operating logic, transmitter learning, and working time settings.
Procedure for learning and removing transmitter codes from the control unit.
Steps for learning and setting automatic or manual working times for the gate.
Visual representation of the advanced menu structure and available options.
Detailed explanations of functions like working times, single wing mode, and factory defaults.
Configuration for analogue edges, automatic learning, radio modes, and step-by-step operation.
Guidance on monthly checks and regular inspection for gate opener safety and operation.
This document is a user manual for the PK300DC/PK350DC Swing Gate Opener. It provides safety instructions, a packing list, technical specifications, installation guidelines, control board wiring, and troubleshooting information.
The PK300DC/PK350DC Swing Gate Opener is designed for single-leaf swing gates. It utilizes a worm and worm gear combined with screw rod transmission for its drive mechanism. The gate opener is intended for installation within an enclosure or yard for protection. It can be controlled via a remote-control unit, which operates in either single-button or three-button mode depending on the specific gate opener type. The system includes safety features such as the ability to unlock the main engine and gate for manual operation using a disengagement wrench. The control unit supports various input types, including photocell, photo stop, analog opening/closing edge, start, and pedestrian start. It also features adjustable slowdown speed and obstacle detection sensitivity. The system can be configured for automatic closing, condominium function, and single-wing mode.
| Specification | PK300DC | PK350DC |
|---|---|---|
| Power Supply | 220V/50Hz; 110V/60Hz | 220V/50Hz; 110V/60Hz |
| Motor Power | 80W | 80W |
| Gate Moving Speed | 18-22 seconds per 90° (approx) | 18-22 seconds per 90° (approx) |
| Max. Single-Leaf Weight | 300Kg | 300Kg |
| Max. Single-Leaf Length | 2.5M | 3.0M |
| Max. Piston Stroke | 34cm | 54cm |
| Max. Force | 1500N | 1500N |
| Remote Control Distance | ≥30m | ≥30m |
| Remote Control Mode | Single button mode | Single button mode |
| Storage Battery (optional) | 24V or 12 VDC | 24V or 12 VDC |
| Noise | ≤58dB | ≤58dB |
| Working Duty | S2, 30min | S2, 30min |
| Recording of Up Remote Controls | 25 | 25 |
| Frequency | 433.92 MHz | 433.92 MHz |
| Working Temperature | -20°C - +70°C | -20°C - +70°C |
| Package Weight | 17Kg | 19Kg |
The control board supports various connections:
General| Brand | Gamatech |
|---|---|
| Model | PK300DC |
| Category | Gate Opener |
| Language | English |
To Next Page