To Next PageTo Next Page
Need help?Do you have a question about the Gambro AK 96 and is the answer not in the manual?
General| Type | Hemodialysis Machine |
|---|---|
| Model | AK 96 |
| Power Supply | 100-240 V AC, 50/60 Hz |
| Manufacturer | Gambro |
| Intended Use | Hemodialysis treatment for patients with renal failure |
| Ultrafiltration Rate | 0-4000 mL/h |
| UF Rate | 0 - 4.0 L/hr |
Provides essential safety guidelines and warnings before operating the machine.
Defines the purpose and scope of the AK 96 dialysis machine's application.
Details the safety principles and protective systems inherent in the machine design.
Provides an overview of the machine's blood circuit components.
Provides an overview of the machine's fluid circuit components.
Describes the components located on the rear of the AK 96 dialysis machine.
Explains how to control and set ultrafiltration parameters during treatment.
Covers battery back-up operation and procedures during power failures.
Outlines the steps to safely start the AK 96 dialysis machine.
Details the automatic safety and calibration checks performed by the machine.
Covers the initial setup procedures, including connecting concentrates.
Explains how to connect and confirm the correct dialysis fluid concentrates.
Provides instructions on correctly attaching all necessary disposables.
Details the procedures for priming the extracorporeal circuit.
Covers parameters setting and patient connection before starting treatment.
Explains how to set and verify all necessary treatment parameters.
Procedures for safely ending and discontinuing the treatment.
Details the setup steps specific to single needle treatment, including expansion chamber.
Guides connecting the patient for single needle treatment.
Covers starting treatment parameters and alarm settings for single needle mode.
Explains how to set and adjust pressure alarm limits for single needle treatment.
Provides general information about isolated ultrafiltration and its applications.
Details the steps for performing isolated ultrafiltration before, during, or after treatment.
Details how to set linear graphs for sodium and bicarbonate concentration changes.
Describes setting linear, step, or interval graphs for ultrafiltration rate adjustments.
Covers general hygiene and maintenance responsibilities for the operator.
Provides a recommended schedule for cleaning, decalcification, and disinfection.
Details the general principles and procedures for heat disinfection programs.
Explains the general procedures and types of chemical disinfectants used.
Covers the procedures for rinse and drain programs.
Provides technical specifications for the machine's control system, including blood flow.
Details the technical specifications for the optional heparin pump.
Covers operating ranges and accuracy for venous and arterial pressure measurements.
