To Next PageTo Next PageWhat to do if Gambro WRO 300 H Water Filtration Systems has low product flow?
If the product water flow is below the preset notification limit, indicating reduced membrane performance, take these steps: First, press the designated button to silence the buzzer. Then, perform cleaning according to local procedures and notify technical personnel.
What to do if Gambro Water Filtration Systems indicates Invalid Water Level?
If the Gambro Water Filtration Systems indicates an invalid water level, which is caused by failure of level sensors in tank, first press the designated button to silence the buzzer. Check that no water has flooded from the tank air vent. The unit can be restarted by pressing the designated button. If the problem continues, notify technical personnel.
What to do if Gambro Water Filtration Systems shows Internal Error?
If you encounter an internal error, which is due to a control unit failure, first press the designated button to silence the buzzer. Then, try restarting the unit. If the issue persists, notify technical personnel.
Why Gambro Water Filtration Systems shows insufficient water supply?
The insufficient water supply is caused by lack of feed water. Check the feed water supply and notify technical personnel.
What to do if Gambro WRO 300 H Water Filtration Systems shows Conductivity Stop?
If the conductivity value has exceeded the stop limit for more than 30 consecutive seconds, you should: Press the button to silence the buzzer. Inform responsible medical staff according to local procedures. The unit can be restarted by pressing the button, but it will stop again if the problem persists. If the problem continues, discontinue dialysis and notify technical personnel.
What to do if there is a Conductivity Alarm in Gambro Water Filtration Systems?
If the conductivity value has exceeded the alarm limit for more than 30 consecutive seconds, take these steps: First, press the designated button to silence the buzzer. Then, note down the conductivity value. After treatment, inform the responsible medical staff according to local procedures and notify technical personnel for further actions.
What to do if Gambro WRO 300 H Water Filtration Systems has a conductivity stop?
If the Gambro Water Filtration Systems initiates a conductivity stop, first press the buzzer to silence it. Inform responsible medical staff according to local procedures. The system can be restarted by pressing the designated button, but it will stop again if the problem persists. If the issue continues, discontinue dialysis and notify technical personnel.
What to do if Gambro WRO 300 H has a conductivity alarm?
If the Gambro Water Filtration Systems triggers a conductivity alarm, first press the buzzer to silence it. Note down the conductivity value. Continue treatment after treatment. Inform responsible medical staff according to local procedures and notify technical personnel for further actions.
General| Application | Hemodialysis water treatment |
|---|---|
| Type | Reverse Osmosis System |
| Model | WRO 300 H |
| Power Supply | 230V, 50/60 Hz |
| Water Quality | Meets AAMI Standards |
| Filtration Capacity | Up to 300 liters/hour (at 15°C) |
| Temperature Range | 5 - 40°C |
Guidelines and procedures for heat disinfection and low flow heat.
Details disinfectants, procedures, residual testing, and Central Chem.
Covers acid and alkaline cleaning, agents, and procedure steps.
Details common alarms like sensor failures, internal errors, and conductivity issues.
Covers alarms related to heat, water supply, chemical processes, and cleaning.
Addresses specific error codes for rinse, intake, temperature, and water level issues.
