Repeating the above steps to set next
feed time, duration and spinning speed.
Press “OK” button to return to “FEED”
mode.
Test Mode
The “Test” mode allows you to test the
unit. Move to “Test” mode by pressing
▲ or▼ buttons. The unit will run after 10
seconds once you press the “OK” button.
The spinning duration is same as that
you set in the first feed.
DO NOT TEST FEEDER WHEN IT CONTAINS FEED. TEST
FEEDER WHEN EMPTY ONLY! TESTING THE FEEDER
WHILE IT CONTAINS FEED WILL CAUSE FEED TO BE
DISCHARGED AT A HIGH VELOCITY AND COULD RESULT
IN BODY INJURY. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR
DEATH!
To Next Page
Loading...