Regardless of the rigging option you choose for your TX5 Spot, always be sure to secure
your fixture with a safety cable. The fixture providers a built-in rigging point for a safety
cable on the hanging bracket as illustrated above. Be sure to only use the designated
rigging point for the safety cable and never secure a safety cable to a carrying handle.
∙The moving head is for spot effect for on-site decoration purpose.
So make sure to operate the fixture until it is in normal temperature.
∙This light should be keep away from strong shaking during any transportation or
movement.
∙Don’t pull up the light by only the head, or it might cause damages to the mechanical
parts.
∙Don’t expose the fixture in overheating, moisture or environments with too much dust
when installing it.
∙Make sure the installation environment is in good safety condition before installing the
fixture.
∙Make sure to put the safety chain and check whether the screws/clamps are screwed
properly when installing the fixture.
∙Make sure the lens are in good condition. It’s recommended to replace the units if there
are any damages or severe scratches.
∙Make sure the fixture is operated by qualified personnel who know the fixture before
using.
TX5 Spot – GAMMA LED Vision
Page 5 of 21
To Next Page
Loading...
