Changing the fuse more than once can increase the repair price, and you can cause a re or a deadly
electrical shock.
These sandlled types can break up to 1000 Ampere current, a normal slow blow fuse can only break
35 Ampere, so it may not stop the current!
If you have light on the front panel and only one channel is playing sound, then take its input cable,
and put it into the quiet channel.
If it still is quiet, then unplug the loudspeaker cable from the OK channel, and use it on the quiet
channel.
If it still refuses to play sound, it is likely to be defective. Call your dealer.
If both channels are silent, but the blue power lights are on, you can check them in the following way:
Switch o power and wait 10 seconds and then switch it on and listen carefully. There should be two
quiet mechanical clicks coming from the inside of the amplier.
If not, disconnect the input cables and try again. Now listen closely to the loudspeaker. A small click
should come from the loudspeaker, just after the click from inside the amplier.
If not, check the loudspeaker cables.
If you hear clicks in the loudspeakers, and still do not get sound, the amplier is probably OK..
If you only get the mechanical click (it comes from the relay closing inside) and you have checked the
loudspeaker cables and the loudspeaker, then you should call your dealer.
If you hear small clicks every second from the loudspeaker, then you have a bad input signal, or a
short circuit on the output, which causes the protection circuit to take action.
Check that the input cable screen is OK and that all plugs are tightly and correctlt connected.
Check the loudspeaker cables. In case you cannot solve the fault by doing the above, call your dealer.
The Service
Most of the parts are on the circuitboard, which can be changed at a low cost, should your amplier
ever need service.
You can contact your dealer, whom may solve your problems locally, or you can contact us in Denmark.
Please note your dealer’s telephone number here:
To Next Page
Loading...
