11
Temperature 1, position »200°«: -200 - +200 °C with temperature probes PT 100
Temperature 2, position »600°«: -200 - +600 °C with temperature probes PT 100
Temperature 3, position »M«: -20,0 - +200 °Cwith infrared sensor IR 40.
If the measured value exceeds the measuring capacity, the figure »1« appears on the left side of
the display screen (3).
Dimensions
Plastic casing: Length 140 mm x Width 90 mm x Height 42/50 mm.
Weight: about 220 g without accessory.
General instructions for UNI 1 and UNI 2
Admissible ambient temperatures
Storage: 5 to 40 °C; temporarily -10 to 60 °C
Operation: 0 to 50 °C, short term -10 to 60 °C not c ondensing
The meter including accessory must not be stored or used in aggressive air or air contaminated by
solvents.
General Remark
The instructions for use of the meter and of the electrodes should be carefully observed to avoid
measuring errors which may occur when trying to simplify the measuring procedure.
Warning
Make sure in any case prior to drilling holes for measuring probes or before driving electrode pins
into walls, ceilings or floors that this happens away from power lines, water pipings or other supply
pipes.
To Next Page
Loading...
