GANSHORN Medizin Electronic GmbH Service Manual Ref.No. 03 140 0 046
PowerCube-Ergo-CASE_ENG_rev.02, 23.11.2012 Chapter 6, Troubleshooting, Checks & Adjustments, page 1 of 16
Chapter 6: Troubleshooting, Checks and Adjustments
General
Trouble Shooting
Flow Chart for Error Analysis „No Data Communication with PowerCube“
Flow Chart for Error Analysis “Error while Determining the Base Line”
Flow Chart for Error Analysis „Invalid Volume Calibration – Drift”
Flow Chart for Error Analysis “Gas Calibration – Delay
Flow Chart for Error Analysis “Gas Calibration – Offset for O2/CO2 too high/
too low”
Flow Chart for Error Analysis “Generally Implausible Ergospirometry”
Checks and Adjustments
Service Program COM98IO
How to Select Measurement Channels for Check and Adjustment
How to Select Switch Channels for Adjustment and checks
Adjustments
General
Layout Analog Module 1.3
Layout Controller Module 1.3
Adjustment of the O2 Analyzer
Adjustment of the CO2 Analyzer
Adjustment of the Sensor Flow PF1
Adjustment of the Suction Flow (Suction Pump)
Adjustment of the Calibration Gas Pressure Regulator
To Next Page
Loading...