1/4
PROGRAMMING TRANSMITTER
CAUTION: If more motors with receiver have to be installed, it is important to
power up only one motor at time during the first programming session,
in order to avoid any interferences with others.
1
Power up the motor to be
programmed.
OFF
ON
2
Press and hold the PROG-TX
button until the motor starts
moving.
3
Check the rotation of the motor,
then release PROG-TX (the motor
stops).
4
Within 5 seconds press the
corresponding button (i.e. UP
if the motor rotates upwards
or DOWN if vice versa).
The transmitter has been
programmed and the rotation of
the motor has been synchronized.
PROGRAMMING
To Next Page
