Need help?Do you have a question about the Garden Star Yard Rover and is the answer not in the manual?
Put on safety gear. Slide axle through axle brackets on the frame.
Slide wheel onto axle (valve stem out), add washer, and secure with cotter pin.
Repeat step two to attach the second wheel with washer and cotter pin.
Secure one leg to the frame using a short bolt, washer, and nylock nut.
Repeat step four to attach the second leg to the frame.
Attach leg brace to both legs using short bolts, washers, and nylock nuts.
Place the handle onto the legs. Bolts will be added in a later step.
Align tray front holes. Insert short bolts through rubber gaskets and tray, add washers and nuts.
Insert shims between tray and handle. Add long bolts through gasket, tray, shim, and handle, then secure with nuts.
Tighten all bolts using wrenches. Inflate tires to max 25psi with a manual pump.
General| Assembly Required | Yes |
|---|---|
| Material | Polyethylene |
| Wheel Type | Pneumatic |
| Number of Wheels | 2 |
| Weight Capacity | 300 lb |
| Tire Size | 10 inches |
| Frame Material | Steel |
To Next Page
