Filament feed
(Tip mechanism):
7
p
The tip mechanism works when the motor is running.
A clean cut is only achieved with the maximum filament length.
During first operation, it may be necessary to extend the cutting
filament several times.
1. Start the trimmer.
2. Hold the trimmer head
7
parallel to the ground and
briefly touch the trimmer
head
7
onto a solid surface
(avoid constant pressure over
extended periods of time).
a
p
The cutting filament
p
is automatically lengthened with an
audible switching process and adjusted to the correct length
with the filament limiter
a
. If necessary tap several times
one after the other.
5. Putting into Storage
Storage: Store out of the reach of children.
v Store your Turbotrimmer in a dry place where it is protected
from frost.
Recommendation:
The trimmer can be suspended by the handle.
The trimmer head is not placed upon any unnecessary strain
if stored in a suspended manner.
Disposal:
(in accordance with
RL 2012/19/EU)
The product must not be added to normal household waste.
It must be disposed of in line with local environmental regulations.
v Important : Make sure that the unit is disposed of via your
municipal recycling collection centre.
6. Maintenance
DANGER!
There is a risk of injury from the cutting filament!
v Always unplug the mains plug of the Turbotrimmer before
carrying out maintenance work!
Risk of injury and risk of damage to property!
v Never clean the trimmer with water or with a water jet
(in particular a high-pressure water jet).
Cleaning the trimmer:
s
0
s
The ventilation slots must always be free of dirt.
v Clean all moving parts after each use, and especially remove
any grass and dirt from the cover
0
and ventilation slots
s
.
17
To Next Page
Loading...
Need help?
General