19
GB
Problem Possible Cause Remedy
Whistling sound Cogged belt slipping. v Have the machine repaired
by GARDENA Service.
Motor will not start Faulty cable. v Check cable.
The conductor cross-section of v Contact your electrician.
the extension cable is possibly
too low.
Motor cuts out because Blocked by foreign bodies. 1. Switch off the motor, re-
blocking protection has move the mains plug from
been activated the socket and wait until
the Aerator has stopped
rotating.
2. Remove foreign bodies.
3. After approx. 1 minute
switch on the Aerator.
Aerating depth too large (aerator 1. Leave motor to cool down.
cylinder has been adjusted for
2. Set adjustment for wear
wear without wear to the knives).
correctly.
The grass is too tall. v Mow the lawn before
aerating (see 3. Function
“Correct Aerating”
).
Aerating results are not Aerator cylinder is worn. v Adjust aerator cylinder
satisfactory (see Maintenance).
Cog-belt faulty. v Have the machine repaired
by GARDENA Service.
Lawn has grown too tall. v Mow the lawn before using
the Aerator.
Aerator cylinder no longer Overload protection (torsion v Replace torsion bar.
turns spring too short) is overturned.
A
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.
8. Storing Your Electric Aerator
To save space the aerator can be folded up by releasing
the wing nuts.
Take care during this process that the cable does not
become trapped.
v Store the Aerator in a dry, closed room to which children
cannot gain access.
1. Switch off motor, unplug from the mains and wait until the
aerator cylinder stops.
2. Move the wear compensation to the transport position and
raise the aerator when transporting it over sensitive surfaces,
e.g. tiles.
Storage:
Transport:
To Next Page
Loading...
Need help?
General
