Gardena smart system smart Sensor 19040 - Page 12

Place the sensor:
8
3
6. Push the sensor into the soil
8
up to the lower edge of the horizontal
part of the sensor head (The sensor needs to be pushed into the soil at
least to the min mark).
Here the measuring area
3
must be in full contact with the damp soil
on both sides.
7. Press down the soil
8
around the measuring area
3
lightly.
8. Water the area around the sensor with approx. 5 litre water.
It may take several hours until the sensor measures the actual soil
moisture.
9. If you place the sensor in the lawn, cut the stripped-off lawn into pieces
and place them around the sensor.
12
en