CAUTION!
8. Troubleshooting
DANGER ! Electric shock !
V Disconnect the Pond Silt Remover at the mains before
rectifying any faults.
Problem Probable Cause Remedy
The Pond Silt Remover Discharge hose wrongly fitted. v The non-return flap in the
sucks nothing up discharge hose should not
be plugged into the filter tray
and must be at the outlet
from the discharge hose.
Pond Silt Remover too high v Position the Pond Silt
above the surface of the water. Remover max. 0.5 m
above the surface of
the water.
Reduced suction power Foam filter, suction tube, suction v Clean the Pond Silt Remover
hose or fine filter bag dirty. (see 7.Maintenance).
The filter bag is full. v Replace filter bag.
The Pond Silt Remover Discharge hose kinked or laid v Lay the discharge hose so
does not empty without a falling gradient. that it is not kinked and has
a slightly falling gradient.
Filter tray and discharge hose v Clean filter tray and
dirty. discharge hose.
Work on the electrical parts must only be carried out by
GARDENA Service.
If other faults occur, please contact GARDENA Service.
9. Technical data
SR 1600 (Art. 7946)
Mains voltage / mains frequency 230 V AC / 50 Hz
Rated power 1400 W
Connection cable 4 m H05-VV
Max. delivery capacity 1600 l/h
Filter tray volume Approx. 27 l
Suction hose length 4 m
Discharge hose length 2 m
Max. particle size for suction 20 mm
Liquid temperature 4 °C - 35 °C
Noise level
1)
<
85 dB (A)
1)
according to 98/37/EC
15
GB
To Next Page