GARDINER TECHNOLOGY GARDTEC 580

Need help?

Do you have a question about the GARDINER TECHNOLOGY GARDTEC 580 and is the answer not in the manual?

Summary

Mains Supply Connection

Terminal Block Connections

Output Terminal Descriptions

Speaker Terminals

Describes wiring for the standard and extension speaker.

PGM 1 Terminal

Provides switch +ve for latching detectors, open collector output at 12V.

PGM 2 Terminal

Provides switched 12V output for latching detectors requiring power reset.

Output Terminal Descriptions (cont)

Power Supply Rating

Details system power limits for sounders, detectors, and auxiliaries.

AUX 12 V Terminals

Supply + and - for detectors like P.I.Rs and vibration sensors.

Remote Keypads

Initial Power Up

System Programming

Set

Allows the engineer to fully set or part-set the system.

Unset

Allows the engineer to unset the system using the engineer code.

Remove

Allows the engineer to remove individual zones when setting.

Test

Allows the engineer to test the system.

Programming Charts

Zone 1 Attributes (Option No.1)

Configures zone type, part set remove, and chime for zone 1.

Zone 2 Attributes (Option No.2)

Configures zone type, part set remove, and chime for zone 2.

Zone 3 Attributes (Option No.3)

Configures zone type, part set remove, and chime for zone 3.

Zone 4 Attributes (Option No.4)

Configures zone type, part set remove, and chime for zone 4.

Zone 5 Attributes (Option No.5)

Configures zone type, part set remove, and chime for zone 5.

Zone 6 Attributes (Option No.6)

Configures zone type, part set remove, and chime for zone 6.

Zone 7 Attributes (Option No.7)

Configures zone type, part set remove, and chime for zone 7.

Sounder Level (Option No.8)

Adjusts speaker volume for Entry/Exit tone and Chime.

Full Set Exit Time (Option No.9)

Sets the exit time duration for a full system set.

Part Set Exit Time (Option No.10)

Sets the exit time duration for a part system set.

Setting Modes (Option No.11)

Defines the system's Full and Part-set modes.

Part-set Sounders & Output 1 Mode (Option No.12)

Controls part-set sounder behaviour and output 1 terminal.

Entry Time 1 (Option No.13)

Programs the primary entry time for the system.

Entry Time 2 (Option No.14)

Programs the secondary, louder entry time.

Sample Programming Session

Engineer Modes

Setting the System

Details the process for setting the system via engineer modes.

Removing Zones

Details the process for removing zones via engineer modes.

Testing the System

Details the process for testing the system via engineer modes.

Viewing the Log

Details the process for viewing the system log via engineer modes.

Setting Chime On;Off

Details the process for enabling or disabling the chime function.

Changing Engineer Code

Details the process for changing the engineer access code.

Resetting After an Alarm

Any Code

System resets on next 'Any Code' arming.

Master Code

System resets if Master or Engineer code is used for arming.

Engineer Code

System resets only if Engineer Code is used for arming.

Anti-Code

To Reset System

To Reset by Anti-Code

Programmable Options Description

Fault Finder

Control Panel will not power up from the mains supply

Display shows a zone fault and Panel will not set after exit time has expired

Control Panel gives a tamper fault

Tripping a detector does not cause an alarm and is not registered at the Control Panel

External sounder does not sound

External sounder rings without the Control Panel triggering it

Tamper is not tripped when detector cover is removed

Detectors false alarm

Control Panel shows Lid Tamper when cover is in place

User and or Engineer code have been forgotten

Gardtec 580 Specification