What to do if my Garland RTCS GME36-I14C induction cooktop is heating inconsistently?
If your Garland Oven induction cooktop heats inconsistently, make sure you are using only the recommended types and sizes of pans. This can often resolve heating issues.
Why does my Garland RTCS GME36-I14C show an error message on the induction appliance?
If an error message appears on your Garland Oven induction appliance, you should refer to the integrated fault diagnostic system for specific error details. This system is designed to help you understand and resolve the issue.
How to fix a Garland RTCS GME36-I14C when the induction appliance does not turn on?
To resolve the issue of a Garland Oven induction appliance not turning on, ensure the appliance is properly connected to the power supply. This is the first step in troubleshooting power-related problems.
General| Category | Oven |
|---|---|
| Model | GME36-I14C |
| Fuel Type | Gas |
| Width | 36 inches |
| Number of Burners | 4 |
| Construction | Stainless Steel |
Defines DANGER, WARNING, CAUTION, and NOTICE terms used in safety instructions.
Explains hazard symbols like DANGER, HIGH VOLTAGE, and Electromagnetic Field found on the equipment.
Stipulates that installation must be done by registered contractors adhering to regulations.
Details minimum clearances required and the importance of maintaining unobstructed air vents.
Emphasizes that electrical connections must be made by certified contractors following codes.
Provides safety warnings regarding utilities, equipment use, and potential hazards like burns or electromagnetic fields.
Provides a table with minimum clearance dimensions (X, Y, Z, W) for installation.
Details electrical load per phase, amperage, and notes on power supply cable requirements.
Guides on making electrical connections, including routing cables from rear or bottom.
Provides safety warnings related to appliance condition, cords, electromagnetic fields, and physical stability.
Details personal safety measures, including utility lockout, appropriate equipment, and burn prevention.
Reiterates the danger of electrical voltage and the need for authorized service personnel.
Lists error codes and flash code sequences with corresponding problems and recommended actions.
To Next Page
