· Select “STOP” and press the ENT key with the cursor over “OK?” to
stop the transfer and continue normal operation.
To transfer waypoints and routes from one GPS 100 to another...
· Select “RECEIVE (UPDATE)” or “RECEIVE (REPLACE)” on the
Data Transfer Page of the unit to receive the waypoints and routes.
· Move the cursor over “OK?” and press the ENT key.
· Select “TRANSMIT” on the unit that will transmit waypoints and
routes.
· Move the cursor over “OK?” and press the ENT key.
· The receiving GPS 100 will display the message “WPT/RTE RX
STARTED” when the first data record is received. The number of
received waypoints and routes will be displayed on line 2 (the
transmitting GPS 100 will also display the number of waypoints and
routes transmitted).·
The transmitting GPS 100 will display the message “WPT/RTE TX
COMPLETE” when all data has been transmitted.
· Select “STOP” and press the ENT key with the cursor over “OK?” to
stop the transfer and continue normal operation.
NOTE: While a GPS 100 is receiving or transmitting waypoint and route
data, only the Message Page may be viewed (i.e., any keypress to access
another page will result in the error tone).
11-13
To Next Page
Loading...
Need help?
General
