Garmin Vector 2S - Entering the Crank Length; Setting the Installation Angle; Troubleshooting; Getting the Owners Manual

8
E
N
Entering the Crank Length
The crank length is often printed on the
crank arm.
1 Rotate the pedals a few times in
order to activate Vector.
2 From the home screen, select >
Sensors > > Sensor Details >
Crank Length.
3 Enter the crank length, and select .
Setting the Installation Angle
Before you set the installation angles, you
mustsettheEdgedataeldstodisplay
power and cadence.
1 Go for a short ride on a trainer or on
the road.
2 Ride until the cadence is nearly 70
rpm.
3 Accelerate smoothly to approximately
90 rpm.
When the installation angles are
successfully set, a message appears
anddataeldsdisplaypowerdataon
the Edge device.
Troubleshooting
Getting the Owner’s Manual
You can get the most recent owner’s
manual from the web.
1 Go to www.garmin.com/vectorowner.
2 View or download the full owner’s
manual in your preferred format.