Need help?Do you have a question about the GarrettCom MNS-6K 4.1.4 and is the answer not in the manual?
Steps for initial login using default manager and operator credentials.
How to configure IP address, subnet mask, and default gateway for the switch.
Explains why an IP address is crucial for switch management and functionality.
Procedures for saving and loading switch configurations using network protocols.
How network access to the Magnum MNS-6K can be secured via IP or MAC address.
Procedures for changing manager and operator passwords.
Feature to block unauthorized MAC addresses from accessing the network via ports.
Steps to configure port security, including auto-learning and MAC address specifications.
Explains the use of RADIUS for port-based network access control via 802.1x.
Explains TACACS+ for access control, providing authentication, authorization, and accounting.
Commands and procedures for creating and configuring VLANs.
How STP ensures a single active path by blocking redundant paths to avoid loops.
Commands to set up and configure RSTP on MNS-6K switches.
Introduces S-Ring and LLL for fast fault recovery in ring topologies.
Explains S-Ring's ring topology for fast recovery and LLL for rapid MAC address relearning.
Steps to authorize and configure S-Ring capabilities using a license key.
Simplifies network redundancy at the edge using dual-homing.
Topology allowing device connection via two independent points for reliability.
Commands used for setting up and configuring dual-homing.
LACP groups physical ports into a single logical channel for increased throughput and reliability.
How to configure LACP, including trunking and valid connection schemes.
QoS capability to provide different priorities to traffic for improved network performance.
Supports port-based, tag-based, and ToS-based QoS configuration.
Commands for IGMP configuration, enabling/disabling, and setting modes.
Commands for configuring GVRP, including port states and static VLAN conversion.
SNMP enables network management through software packages for monitoring and configuration.
Commands and variables for configuring SNMP, including v1, v2c, and v3 parameters.
Deciding which version of MNS-6K software to use and preparing tools.
Detailed steps for downloading MNS-6K software from GarrettCom's FTP site.
Recommends preserving the existing switch configuration before software upgrade.
Mentions three capabilities required for saving configuration before proceeding.
General| Brand | GarrettCom |
|---|---|
| Model | MNS-6K 4.1.4 |
| Category | Software |
| Language | English |
To Next Page