TIMER: AUTO START/
STOP FEATURE:
Press Timer
button
AIR CONDITIONER FEATURES (CONTINUED)
CHECK FILTER FEATURE:
Press Check
Filter button
8
NOTE:
This feature is a reminder to clean the Air Filter for
more efficient operation. The LED (light) will illumi-
nate after 250 hours of operation. To reset after
cleaning the filter, press the Check Filter button and
the light will go off.
NOTE:
the Auto Start program is initiated.
- Press or hold the UP or DOWN button to change the
then
at 1 hour
increments
up to 24 hours. The control
will
count down the time
remaining until start.
- The selected time will register in 5 seconds, and the
system will automatically revert back to display the
previous temperature setting or room temperature when
- Turning the unit ON or OFF at any time or adjusting
the timer setting to 0.0 will cancel the Auto Start/Stop
timed program.
press the
illuminates. It indicates the Auto Stop program is
initiated.
Auto-timer settings
the room temperature.
OO
unit and plug it back in. If error repeats, call for
service.
NOTE: is displayed as shown in the left picture.
plug it back in. If error repeats, call for service.
""
Error codes:
Unplug the unit
and
plug
it back in. If error repeats, call for service.
Display
#
- When the unit is on or off, first press the Timer button
.
The TIMER ON indicator light illuminates. It indicates
Timer button again. The TIMER OFF indicator light
- When the time of TIMER ON is displayed
Auto time by 0.5 hour increments, up to 10 hours
the unit is on.(When the unit is off,there is no display.)
#
It
#
NOTE: In Fan only mode,it will display "LO"or "HI".
#
#
#
Mode Mode
Auto
Auto
DISPLAY :
shows the set temperature in "C"or "F"and the
.
While on Fan only mode, it shows
AS-Room temperature sensor error -
-Evaporator temperature sensor error-Unplug the
HS -Electric heating sensor error-Unplug the unit and
To Next Page
Loading...
