Need help?Do you have a question about the GAS GAS FSE 400 and is the answer not in the manual?
Procedure for removing the original clutch components.
Procedure for installing the new APTC clutch components.
Procedures for cylinder head dismounting, inspection, and mounting.
Procedures for checking cylinder deformation and interior wall wear.
Measurements and checks for piston diameter, ring gap, and grooves.
Procedures for changing engine oil and oil filter.
Procedure for removing the original clutch components.
Procedure for installing the new APTC clutch components.
Procedures for cylinder head dismounting, inspection, and mounting.
Procedures for checking cylinder deformation and interior wall wear.
Measurements and checks for piston diameter, ring gap, and grooves.
Procedures for changing engine oil and oil filter.
To Next Page
General