Need help?Do you have a question about the GAS Thaedra and is the answer not in the manual?
Input Specifications| input impedance | Approximately 600 ohms |
|---|---|
| input sensitivity | Approximately 67 microvolts @ 1 KHz |
| input overload | Approximately 4.7 millivolts @ 1 KHz |
Output Specifications| output impedance | Approximately 500 ohms |
|---|---|
| main output impedance | 5 ohms |
| tape output load impedance | Not less than 10K ohms |
Noise Specifications| equivalent input noise (20-20KHz) | Less than 0.1 microvolt |
|---|---|
| equivalent input noise (400-20KHz) | Less than 0.04 microvolt |
| equivalent input noise (high level inputs) | Less than 5 microvolts 20-20KHz |
Key operational advice including power-on sequence, level adjustment, input jacks, and ventilation.
Describes the push-push power switch, its time-delay relay, and proper turn-on/off procedures.
Explains the main volume control for simultaneous channel adjustment, noting its stepped construction.
Details the control for adjusting left/right channel ratio for sound stage balancing.
Covers the bass and treble controls that alter low and high-frequency response respectively.
Explains the four-position low-frequency attenuation control for rumble reduction.
Describes the MODE switch for stereo/reverse and TAPE MONITOR/COPY functions for tape deck interconnection.
Details gain, impedance, sensitivity, overload, and noise for the Head Amp input.
Lists specifications for the magnetic phono input, including gain, impedance, and sensitivity.
Provides specs for gain, impedance, sensitivity, overload, and noise for high-level inputs.
Outlines output impedance for main and tape outputs, and load impedance requirements.
To Next Page
