IOM GMI 2M & 2ML Nov 2010.doc
10
WARNING
Exceeding the maximum allowable gas manifold pressure could result in
over-firing of the unit and may cause permanent damage to the unit.
NOTES
¾ Air and gas flow rates are factory adjusted for optimum combustion
quality. Note that these settings may vary slightly at different site
conditions (calorific value of gas, duct length, etc.).
¾ After installation is completed, using a gas analyzer, the CO and O
2
contents of the exhaust gases should be re-checked to ensure their
compliance with those achieved at the factory and reflected in the test
report provided to your local Gasmaster representative.
¾ IF adjustments to the factory settings of air and gas flows are made,
ensure that the manifold gas pressure does not exceed the pressure
specified on the boiler label.
To Next Page
Loading...