IOM GMI 2M & 2ML Nov 2010.doc
14
2.1 Boiler/Water Heater Package
Each unit is supplied with:
1. Riello burner/blower.
2. Inlet and outlet manifolds.
3. High temperature cut off switch with manual reset.
4. Operating temperature controller.
5. Pressure relief valve.
6. Fully assembled gas train.
7. One Temperature sensor installed on the outlet manifold
8. Condensate drain connection.
9. Flame sensor (inside burner).
10. Flue gas connection.
11. Pressure-Pressure/temperature gauge.
12. One purge valve installed at the inlet of each coil.
13. All Safety features as described in Section 1.3.
Please contact Gasmaster Industries if items listed above are missing. Please be familiar with
major parts of the boiler before operating. Always exercise caution when transporting.
Instructions provided are only general guides, and are not substitute for common sense and sound
safe practices.
To Next Page
Loading...