TRANSPORTATION
Always carry the unit with the engine
stopped, the guide bar covered with the
protector to the rare, and muffler away
from your body.
5. INSTALLING GUIDE
BAR AND SAW CHAIN 6.FUEL AND CHAIN OIL
Open the box and install the
guide bar and the saw chain
on the power unit as follows:
The saw chain has very sharp
edges. Use thick protective
gloves for safety.
1. Pull the guard towards
the front handle to check
that the chain brake is
not on.
2. Loosen the nuts and
remove the chain cover.
3. Install the attached spike
to the power unit.
4. Gear the chain to the
sprocket and while fitting
the saw chain around the
guide bar, mount the
guide bar to the power
unit. Adjust the position
of chain tensioner nut on
the chain cover to the
lower hole of guide
bar.(F1)
(1)Tensioner nut
(2)Chain cover
NOTE
Pay attention to the correct
direction of the saw chain.(F3)
（
（（
（ 1 ）
））
） Moving
Direction
1. Fit the
chain cover
to the
power unit
and fasten
the nuts to
finger
tightness.
2. While
holding up
the tip of
the bar
adjust the
chain
tension by
turning the
tensioner
screw until
the tie
straps just
touch the
bottom side
of the bar
rail.(F3)
3. Tighten the
nuts
securely
with the bar
tip held
up(12-15
N.M).Then
check the
chain for
smooth
rotation
and proper
tension
while
moving it
by hand.
If necessary,
readjust
with the
chain cover
loose.
4. Tighten the tensioner screw.
(1) Loosen
(2) Tighten
(3) Tensioner screw
NOTE
A new chain will expand its length in
the beginning of use. Check and
readjust the tension frequently as a
loose chain can easily derail or cause
rapid wear of itself and the guide bar.
WARNING
To Next Page
Loading...
