EasyManua.ls Logo

Gastroback WAFFLE IRON ADVANCED CONTROL - Page 92

Gastroback WAFFLE IRON ADVANCED CONTROL
120 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
92
Problem Possible Reason The Easy Solution
No respond to the buttons
or the browning control
dial.
Restart button: the
appliance is still pre-
heating.
The baking cycle cannot be started during pre-heating.
Wait until the required temperature is reached and the
browning indicator dashes illuminate continuously.
Menu button and
browning control
dial: a program is run-
ning or the manual control
“CUSTOM” is activated.
After starting a program or the manual control
(“CUSTOM”) no other program can be selected and the
browning control dial is deactivated. After starting a pre-
defined program: Wait until the program is finished. After
activating manual control (“CUSTOM”) via starting the
baking time: switch off the appliance shortly via the power
button. When switching on thereafter, all settings are
available again.
Your waffles are not done,
after the baking time
elapsed.
An unsuited program is
selected.
- Close the lid again and leave the waffles bake for some
more seconds, and/or
- Select another program and/or
- Select a darker browning level and/or
- Use the manual control “CUSTOM” and bake the batter
for an appropriate time.
Note: When using whole meal instead of plain flour for
your waffle recipe, the required baking time may differ
significantly.
The waffles are too dark,
hard, and/or dry.
You used an insufficient
program.
Select another program with a shorter baking time.
The browning level is set
too dark.
Select a lighter browning via the browning control dial.
The waffles stick to the
waffle plates.
The non-stick coating has
not been prepared for
operation.
Switch of and unplug the appliance. Leave the appliance
cool down sufficiently and clean the appliance. Thereafter
rub the waffle plates with some droplets of cooking oil ,
before using the appliance again.
The appliance did not
reach the required start
temperature, when you fil-
led in the waffle batter.
Before filling in the batter, always wait until the browning
indicator dashes do not flash any longer.
The waffles are not done.
The baking time is too
short.
Close the lid and leave the waffles bake for some more
seconds. However, consider that baking waffles is a mat-
ter of only a few minutes and seconds. Do not leave
the waffles within the appliance for a too
long time. Otherwise your waffles may burn.

Table of Contents