GC®32TSi™ Safety and Operation Manual | 7
Position the lifting device over the center of the crimper and
attach the slings then slowly raise the crimper and place it on a
suitable table.
Fit 5/8" (M10) bolts, nut and washers into pre-drilled holes and
tighten.
Secure the crimper to bench. If using the optional stand, bolt
crimper using the four 6mm Allen head bolts (included) through
predrilled holes. If mounting to a bench, drill four ½" holes aligning
with holes in crimper and bolt together.
Remove the slings and store.
Oil reservoir is shipped full. Remove plug and replace with
breather cap, store plug. Always ship crimper with plug
installed to avoid spillage of hydraulic fluid or contamination
of breather element. Check the sight glass to make sure oil
level is half way with the head fully retracted (open).
INSTALLATION: SAFELY MOVING CRIMPER
INCORRECT LIFTING
DO NOT lift crimper by head as this will cause damage to the crimper.
Use lifting anchors on crimper base.
GC32TSi Safety and Operating Manual-A4.indd 7 1/11/17 12:37 PM
To Next Page
Loading...
