Need help?Do you have a question about the GAUSSIAN ROBOTICS Vacuum 40 and is the answer not in the manual?
Click the float button in the lower right corner and select manual operation.
Move the robot to a designated area for maintenance.
Use a wet, lint-free wipe to clean the robot's exterior, avoiding cameras and sensors.
Use a soft, clean, lint-free wipe to clean the laser, camera, and sensors.
Clean the front horizontal laser component.
Clean the top-view camera and touch screen with a soft, lint-free wipe.
Click the float button in the lower right corner and select manual operation.
Move the robot to a designated area for maintenance.
Open the rear shell and remove the dust-mop plate and cloth.
Wash the dust-mop cloth, then air dry it.
Prepare a clean cloth, attach it to the plate, and reattach the plate to the robot.
Click the float button in the lower right corner and select manual operation.
Move the robot to a designated area for maintenance.
Open the side shell, remove the dust box, and clean the guide plate.
Align the guide plate with gaps and insert it into the robot, pushing upward to secure.
Insert the dust box, close the lower shell, and lock the buckle.
Check the driving wheel shaft for debris or hair and clean it.
Release the buckle to open the side shell of the robot.
Unscrew the bolt, release the cover plate, and remove the roller brush.
Clean the side cover of the roller brush and any debris wrapped around the brush. Reinstall after cleaning.
Push the robot to the maintenance site and press the side brush down to remove it.
Clean hair or debris from the side brush. Align and push upward to lock it.
Switch to manual mode and move the robot away from the charging pile.
Unplug the charging pile, clean its exterior with a wet wipe, avoiding the charging port.
Switch robot to manual mode and move it to the maintenance site.
Open the top lid and dust tank cover to remove the dust bag and air filter.
Clean the filter, note its direction, and reinstall it along with the dust bag.
Switch robot to manual mode and move it to the maintenance site.
Open the top lid and dust tank cover to remove the dust bag.
Clean the dust bag, reinstall it, and close the dust tank and top lid.
Open the buckle and detach the side lower shell.
Unscrew the bolt, release the cover plate, and remove the roller brush.
Insert the new roller brush, attach the side cover, screw the bolt, and close the shell.
Push the robot to the maintenance site and press the side brush down to remove it.
Align the new side brush with the pin and push it forward to lock it.
Switch robot to manual mode and move it to the maintenance site.
Open the rear lower shell and remove the dust-mop plate and cloth.
Assemble a clean cloth onto the plate and reinstall the plate onto the robot.
General| Brand | GAUSSIAN ROBOTICS |
|---|---|
| Model | Vacuum 40 |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page