Gauzy LC6 FLEX Controller - DIMMER; High Voltage Dimming Control

10
Gauzy’s smart FLEX Dimming Controller is a state of the art electronic
appliance that allows dimming of Gauzy films. This manual covers the
installation of the FLEX Dimming Controller.
The Dimming functionality of the controller can be
achieved in two dierent ways:
• High voltage control interface – the control commands are performed
by switching the AC net 110/220V LINE to the input DT and DO terminals.
• Dry contact control interface – this feature requires two external dry
contacts or a regular wall switch for operation. The advantage of this
approach is that the control wires do not carry any voltage.
High Voltage Control Interface
High Voltage Dimming Control
1. Before proceeding make sure the main AC voltage is disconnected. Any
electrical connection should be done by a qualified electrician.
2. Connect AC mains to the LINE, NEUTRAL and GROUND terminals
respectively.
3. Connect AC mains LINE to DT-ON/OFF & DO terminals through a regular
3-way switch. This switch is commonly used for electrical curtains.
The next page follows with some examples:
Dimmer
DIMMER
AC OUT
FREQUENCY
STATUS
CASCADE
DRY
CONTACT
COMMON
N.C
OUT OK
ALARM
COMMON
OUT
COMMON
IN
MUTE
DO
COMMON
DT/ON-OFF
LINE
32 HZ
LINE/2
POWER IN
HV CNTL
G
RO
U
N
D
N
.C
N
EU
TRA
L
N
.C
LIN
E
O
N
-O
FF
DT
D
O
Dimmer
Wall Switch
Line
110/220VAC
Film Out
Line
Neutral
Ground
AC mains
110/220VAC