Do you have a question about the GB X1 and is the answer not in the manual?
Adult assembly, child supervision, preventing falls, strangulation, finger entrapment, and stroller as toy warnings.
Avoid overloading handle, canopy pocket, cupholder, and storage basket to prevent tipping.
No stairs, sports, low light jogging, hot beverages, or hazardous surfaces.
Avoid over-inflation, check pressure, lock front wheel for jogging, ensure wheel attachment.
Use specified car seats, ensure secure attachment, secure child in harness.
Discontinue use if damaged, check parts before use.
Guidelines for walking with/without car seat and jogging based on child's age.
Check that you have all parts shown before assembling.
Contact customer service if any parts are missing.
Place flattened carton on floor to protect surface.
Unlock the storage latch before opening.
Lift handle to open until it clicks and locks.
Ensure the stroller is locked in the fully open position.
Push wheel onto rear leg tube until it clicks into place.
Pull on wheels to ensure they are securely attached.
Push button and pull wheel off axle.
Locks for use on rough surfaces like gravel or stones.
To unlock, push the lever to the front.
To lock, push the lever to the rear.
Press lever DOWN to lock the brakes.
Push lever UP to unlock the brakes.
Push buttons and rotate down to lower.
Push buttons and rotate to desired height to raise.
Squeeze the foam area of the wire to brake.
Not intended for use as a parking brake.
Push forward to open the canopy.
Push to the rear of the stroller to close.
Pull the flap forward to access the window panel.
Squeeze button and pull recline strap down.
Push seat up, squeeze adjuster, and draw webbing.
Click straps into the crotch buckle.
Push the button on the crotch buckle.
Adjust straps for fit and ensure same height setting.
Wrap harness covers around the straps.
Push cup onto connector and slide down.
Do not place more than 1 lb (0.45kg) to avoid tipping.
Intended for adult use to maintain stroller control while jogging.
Unfasten buckle, insert hand through loop, hold handle.
Remove car seat adapters and unlock front wheel.
Pull up on levers on both sides of handles.
Rotate handle forward and lock the storage latch.
Unlock storage latch, lift handle to open and lock frame.
Use only GB Asana 35, check secure attachment, prevent child ejection.
Recline seat, attach adapters to frame, confirm attachment.
Align car seat hub with adapters and check latching securely.
Squeeze rear handle and pull car seat up off the stroller.
Press tab behind frame tube to remove adapters.
Stroller will not fold with car seat adapters attached.
Refer to care tag, clean frame with damp cloth, check parts.
Always check tire pressure and store in a dry place away from sun.
Contact customer service for parts, warranty, or online visit.