2. Configuration
Begin by performing a factory reset of the settings in your
IP Doorbell. To default the settings to factory, follow these
steps;
- Apply power to the IP doorbell.
- Within 5 seconds, press and hold the ‘Bell’ button until your
hear a distinctive 1 second long buzzer sound (after approxi-
mately 1 minute, it is preceded by a flash of the illuminator
LED’s). Release the ‘Bell’ button after the buzzer sound stops.
- The IP Doorbell will reset once again (about one minute) and
is ready to start configuration shortly after the illuminator LED’s
flash.
*Note: Performing a factory reset erases settings stored during
the setup process. Do not perform a factory reset after you have
red the IP Doorbell unless absolutely necessary.
*To Proceed with a Wireless (Wi-Fi) installation, go to step 3a.
*To Proceed with a Wired (RJ45) installation, complete step 3a,
then connect the RJ45 cable.
*To Proceed with a Wired (RJ45) installation without any
requirement for a Wi-Fi connection credentials, star
step 3b
(advanced).
configu
t at
To Next Page
Loading...
