GBS 4all - Set up by Manual Search

3
If none key works or some key work but most keys work improperly,
please try other codes in the same brand (for example: code
028,030 ...under SONY TV), repeat step a-e till you find one code
which work good enough.
Remark: In the process of setup, if you want to quit from setup mode,
please press device key. (If no key pressed in 10 seconds, the
remote control will leave the set up mode automatically.)
B. Set Up by Manual Search:
After you have set up by device brand code several times, the remote
control still doesn't work (i.e. The device still can not be controlled by
this remote control), or you can not find the correct code in the Device
Brand Code List, you can use "Manual Search" to find out the reactive
Code:
a. Power on the device that you want to control. If it is a VCR, it must be
inserted with a tape.
b. Press and hold the [SET] keys. Then press the device key in remote
control, such as [TV], [VCR], [AUX], etc
c. The LED will be on at moment. Then release the pressed keys.
d. Point the remote control to the device, strike the [POWER] key. If it's
VCR/CD/DVD/TUNER
/TAPE/AUX, you can press either [POWER] key or [PLAY] key, the
remote control enters into" Manual Search" mode and the LED keeps
flashing.
e. See if device reacts or not. If it works, turn to step f; If not, repeat step
d every 1 second.
f. Test other keys. If keys work well enough, press the device key to
quit from the search mode. If most keys don't work well enough,
repeat step d-f to find the best code.
Remarks:
a. Whenever you want to leave or change search mode, press the
device key to quit, and the LED will turn off.
b. In the Manual Search Mode, besides the [POWER] key ([POWER]
key and [PLAY] key in case of VCR/CD/DVD/TUNER/TAPE/AUX),
all other keys' function can be checked normally. That is to say you