4
can test other keys without leaving Manual Search mode. It will
leave Manual Search mode automatically if no key pressed in 30
seconds.
c. You may use the SET key to change the search direction from
forward to backward or from backward to forward.
d. After you press [POWER] 154 times in TV (or 137 times in VCR, or
220 times in CBL/SAT, or 146 times in AUX, 95 times in CD, or 99
times in TUNER, or 107 times in TAPE, 59 times in DVD). If device
still does not react from remote control that means this remote
control may not work for your device.
C. Set up by Auto Search
：
This search is similar to Manuel Search except it transmits
power signal automatically instead of manually pressing the power
key during the search:
a. Power on the device you want to control. If it is a VCR, it must be
inserted with a tape.
b. Press and hold [SET] key, in the meantime, press and hold the
Device key that you want to control. (for example: TV) for more
than 3 seconds and then release them, the auto search begins.
The remote control enters into Auto Search, LED flash, and remote
control transmit power signal every 2.0 second automatically.
c. See if device react or not, once the device reacts, press any key
(except SET key) to stop the search.
d. Test if other keys work well enough. If most keys work not good
enough, Auto Search again to find next reactive code and try until
you find the best code.
Remark:
a. You must point your remote control to the device that you want to
control during Auto Search.
b. Whenever you want to leave Auto Search mode, press any key
(except SET key) to quit, and the LED will be
Off. The search is over.
c. When remote control search through all codes (about 10 minutes),
then the remote control will quit from Auto Search process
automatically.
d. In case of you did not stop the search on time when device reacted,
To Next Page
Loading...
